WIP Sazabi (build 1)

Started to build and not all parts fit right and had to make some adjustments

for example:

The blue surrounded part would fit because it was to small, so to fit i had to cut it in half (A)

To extend the part i used some styrene (B) and reinforced it with some putty (A) on top of that i will glue another styrene plate

perfect fit...only some sanding left to do

Another small fit problem but very easy to solve!

This parts would't allign with it's base (red lines)

But found the source of the problem! Just had to sand and cut some resin almost to easy!

There's a small gap left but nothing to worrie about because most of this panel will be covered up by another panel.